The Revolabs Classroom Wireless Amplification System allows the teacher to speak in a normal voice and the students can hear every word. Automatically selects RF channels to avoid interference; it does not require the teacher to change channels to avoid interference as with IR Systems. The classroom System power levels can be easily adjusted to allow systems to be used in adjacent classrooms. Includes a charger base, transmitter/receiver, and the Revolabs RF Armor Wireless Wearable Microphone.

 

Unobtrusive Microphone
The Classroom Amplification System includes a Revolabs RF Armor™ Wearable Wireless Microphone. It is small and ultra light, measuring just 2.5 inches high, about one inch across and weighing mere ounces.  Also, it is impervious to GSM noise from cell phones and PDAs. 

 

Rechargeable, No Batteries or Battery Packs
The Revolabs Wireless Microphone is rechargeable and the battery provides eight hours of talk time, a full school day, so there are no batteries or battery packs to worry about.  A recharge to 85 percent capacity can be attained in about 45 minutes.  The System includes a Charger Base which can be put anywhere there is a standard electrical outlet.  This allows the Wireless Microphone to be stored and charged in a locked office or closet. 

 

Cost-effective
The Revolabs Classroom Wireless Amplification System comes with everything needed to install an amplification system in a classroom environment, including two speakers with wall mounts, a Charger Base, a Transmitter/Receiver, the Revolabs RF Armor Wireless Microphone, and all of the cables needed to install the system. 

Easy-to-Use
Once installed, the teacher or professor simply removes the Wireless Microphone from the Charger Base, clips it on a lapel or the lanyard provided, and un-mutes the System by pressing the Mute Button on the microphone.  The microphone is muted when it is removed to eliminate any noise that may occur while the teacher puts the microphone on.  The Mute Button is very accessible and can be turned on and off easily.  When finished with the microphone, it is placed back in the Charger Base to recharge.

Easy-to-Install
Simply wall-mount the speakers, and run the speaker wire between the two speakers.  Attach the Transmitter/Receiver Box to the powered speaker, cable them together and plug them both into a wall power outlet. Charge the Wireless Microphone in the Charger Base after plugging the Base into a power source.